engineering welding, engineering technology, welding surface, engineering welding technology surface spatter cure


APPLICATION PROCEDURE 1. Shake the container before use. 2. The application surface would be free from oil, grease, fat etc. 3. Apply the coating with a brush on the surfaces which are to be welded. One layer of coating (0.20 mm approx. thickness) is sufficient but in certain cases where more heavy spatters are expected to be generated, two layers of coating (0.4mm approx.) are recommended.
4. The place where Arc is to be produced should be coated. 5. The coating should be dried before welding is carried out.
6. After welding, use a separate dry bruch and remove the coating alongwith the spatter particles from the welded product.
7. In case the Spatter Cure SC-07 gets thicker, use only SC-CA to reach a level of its original fluidity (a dense of 1.33 gms/cc before welding)

developed by Web Seekers (webseekers.in)